RX Codec Gain (MENU_CODEC_GAIN_MODE)
Sets the Codec IQ signal gain.
Higher values represent higher
gain. If set to AUTO the mcHF
controls the gain so that the best
dynamic range is used.
RX/TX Freq Xlate (MENU_RX_FREQ_CONV)
Controls offset of the receiver IQ
signal base frequency from the
dial frequency. Use of +/-12Khz
is recommended. Switching it to
OFF is not recommended as it
disables certain features.
Mic Input Gain (MENU_MIC_GAIN)
Microphone gain. Also
changeable via Encoder 3 if
Microphone is selected as Input
Line Input Gain (MENU_LINE_GAIN)
Line IN gain. Also changeable via
Encoder 3 if Line IN Left (L>L) or
Line IN Right (L>R) is selected as
Input
TX Audio
Compress (MENU_TX_COMPRESSION_LEVEL)
Control the TX audio
compressor. Higher values give
more compression. Set to
CUSTOM for user defined
compression parameters. See
below. Also changeable via
Encoder 1 (CMP).
TX ALC Release Time (MENU_ALC_RELEASE)
If Audio Compressor Config is
set to CUSTOM, sets the value of
the Audio Compressor Release
time. Otherwise shows
To Next Page
Loading...