Recent RS-918SSB - Page 32

LABEL (NR)
DESCRIPTION
the XVERTER
Offset to the LO
Frequency of it.
The mcHF
frequency is
multiplied by
this factor
before the
offset is added,
so anything but
1 will result in
each Hz in the
mcHF being
displayed as 2
to 10 Hz change
on display.
XVTR Offset (CONFIG_XVTR_FREQUENCY_OFFSET)
When
transverter
mode is
enabled, this
value is added
to the mcHF
frequency after
being multiplied
with the XVTR
Offs/Mult. Use
Step+ to set a
good step
width, much less
turns with the
dial knob if it is
set to 1Mhz
Step Button Swap (CONFIG_STEP_SIZE_BUTTON_SWAP)
If ON, Step-
behaves like