Owners/Installation Manual – Controller v2 | Reclaim Energy
RECLAIMENERGY.COM.AU
5
V1 V1.1 V2
STATUS DISCONTINUED
FROM 2023
AVAILABLE FROM
FEBRUARY 2023
SOFT LAUNCH
FROM APRIL 2023
Connectivity
to heat pump
RJ 45 cable
RJ 45 cable Modbus
Connectivity to PV
inverters and home
management systems
Not available Dry Contact
Connectivity to
Reclaim Mobile app
using house Wifi
Not available Available
Option 1 24/7 time-block
Option 2 10 pm – 7 am
Option 3 Midnight – 6 am
Option 4 10 am – 4 pm
Option 5 Two time-blocks –
first must be set for a
minimum of 6 hours and
second can be set as
little as 0 hours!
Two time-blocks – first must
be set for a minimum of 3
hours and second can be set
as little as 0 hours!
Two time-blocks – first must be set
for a minimum of 3 hours and
second can be set as little as 0
hours!
Additionally, the turn on temperature
can be adjusted for the second time
block (i.e., default is 37°C)
Option 6 N/A
One shot boost is activated by
a dry contact signal from
home management or PV
inverters or dry contact
smart switches.
This is called “Remote”
option.
Two time-blocks – first must set for
a minimum of 3 hours and second
can be set for as little as 0 hours!
Additionally, both turn on and turn off
temperatures can be adjusted for the
second time block (i.e. default is 37°C
& 59°C respectively).
Option 7 N/A
One shot boost is activated by a dry
contact/modbus signal from home
management or PV inverters or dry
contact smart switches. This is
called “Remote” option.
Additionally, a time clock should be
adjusted for when the signal is not
received by the controller in the
18-hour cycle (i.e. this is to ensure
any legionella bacterial growth is
controlled in a 24 hour cycle).
Boost function Available
Manuals Website
Table B: Key updates on the Reclaim Energy controllers
To Next Page
Loading...
Need help?
General