Reclaim Energy | Owners/Installation Manual – Controller v2
6
Case tools required Phillips 1 screwdriver for lid screws (if required to remove
cover)
Pozi 2 screwdriver for mounting screws
READ THESE SAFETY PRECAUTIONS and
LIMIT OF LIABILITY BEFORE YOU BEGIN
The following pages contain instructions for qualified
personnel only. They involve potentially hazardous
adjustments and high voltage mains wiring information.
General Safety
Precautions
The installation is to be checked at least annually for damage
or malfunction. All servicing is to be carried out by qualified
personnel only. All aspects of the installation must comply
with local electrical and plumbing regulations.
WARNING These products are not designed for use in, and should not be
used for, applications which are in conjunction with items that
are critical to any person’s health (e.g., life support systems).
For any critical installation, independent fail-safe back-up
systems must always be implemented.
Installation
Precautions
Make sure the controller is installed out of direct sunlight,
flammable liquids, or radiant heat sources. Power leads must
face directly down.
Ensure controller is in a safe environment for users to inspect
display panel.
Sensor leads should be kept 300mm (12 inches) away from
mains and comms cables if run parallel to those cables.
A readily accessible power disconnect device is required.
CAUTION
Dangerous Voltages may be present.
No user serviceable parts.
Protective enclosure must only be opened
by qualified personnel.
Remove ALL power sources before removing
protective cover. The Reclaim Controller must
be installed by a qualified person.
Ensure suitable over-current protection and RCD
protection for the Reclaim Controller is in place.
BEFORE YOU BEGIN INSTALLATION
To Next Page
Loading...
Need help?
General