Record R 62 - Page 19

R62 SECUTEC Parameter
D = Wert wird beim Laden der Defaultparameter nicht zurückgestellt
≥ V0.13.0
└►
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└►
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└►
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
└► OFF ON
start signal for the selected voice message
ReserveOut7
ReserveOut1
ReserveOut2
ReserveOut3
ReserveOut4
ReserveOut5
ReserveOut6
Voice1In4
Voice1Start
AUX22_OUT
AUX23_OUT
AUX12_OUT
Flash
not used
not used
programmable output AUX22_OUT
not used
programmable output AUX12_OUT
flashing lights outside the door
not used
programmable output AUX23_OUT
Voice1In2
Voice1In3
Outputs 48..63
(read only)
(read only)
(read only)
GreenSecIn
RedPubIn
GreenPubIn
AUX11_OUT
AUX21_OUT
Voice1In1
Outputs for voice card. Messages are selected by the binary code
of the 4 output signals
programmable output AUX11_OUT
(read only)
Buzzer
RedSecOut
GreenSecOut
RedPubOut
GreenPubOut
RedSecIn
(read only)
(read only)
StgSecSSK
StgPubSurV
StgPubSSK
Light
SwTraps
Voice1Busy
AUX22_IN
StgSecSurV
Outputs 32..47
(read only)
(read only)
programmable input AUX22_IN
red traffic light secure door outside
green traffic light secure door outside
command open public door
green traffic light public door outside
SensorC2
SwDoorSecIn
SensorC1
BdeS2
BdeS3
SensorC3
SwDoorSecOut
BdeS1
SuperUserSec
SuperUserPub
SwDoorPubOut
SwDoorPubIn
AUX12_IN
(read only)
Inputs 16..31
contact public door outside (push button, code card reader, etc.)
contact for temporary deactivation of the sensor (contact mat,
tailgating, etc.) to pass through from public side to secure side
(read only)
(read only)
BDE-S contact 2
BDE-S contact 3
programmable input AUX12_IN
(read only)
contact public door inside (finger print, code card reader, etc.)
contact secure door outside (push button, code card reader, etc.)
contact secure door inside (finger print, code card reader, etc.)
(read only)
BDE-S contact 1
(read only)
lighting
command open secure door
contact for temporary deactivation of the sensor (contact mat,
tailgating, etc.) to pass through from secure side to public side
service flap is open
output of the voice card when busy
buzzer
contact status sensor "room empty"
contact status sensor "decision YES"
contact status sensor "decision NO"
command lock public door
command lock secure door
(read only)
(read only)
green traffic light secure door inside
(read only)
(read only)
(read only)
(read only)
not used
not used
not used
(read only)
(read only)
(read only)
(read only)
(read only)
programmable output AUX21_OUT
red traffic light public door inside
green traffic light public door inside
(read only)
red traffic light secure door inside
red traffic light public door outside
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)
(read only)