To Next PageTo Next PageWhat to do if my red lion RL-SWJ fails to deliver water?
If your Red Lion Water Pump isn't delivering water, it might not be fully primed, so fully prime the pump. The suction lift may be too great, so reduce it. Check the foot valve to ensure it is properly installed, not buried, submerged, or plugged. Also, make sure that the restrictor valve is open.
How to fix a Red Lion Water Pump that loses prime?
If your Red Lion Water Pump loses prime, inspect the suction line for air leaks. Ensure the well isn't drawing down too far. Replace any faulty foot valve. Have an electrician install a low pressure cut-off switch to prevent critical failure. Install or adjust a restrictor valve to offset available capacity.
What to do if my red lion RL-SWJ delivers water but not at rated capacity?
If your Red Lion Water Pump isn't delivering water at its rated capacity, several factors could be responsible. Check for leaks in the suction or discharge line and repair them. Clear any partial plugs in the foot valve, suction line, impeller, or nozzle. Adjust the suction lift to recommended levels. Inspect and correct the impeller rotation and speed. Ensure the Venturi or diffuser isn't plugged. Verify the motor is wired for the correct voltage and check/correct the line voltage at the motor. If applicable, replace or properly install the filtration cartridge. Replace any faulty air volume control. Inspect for air leaks in the tank above the water level. Ensure that the pressure switch settings are correct. Finally, service the tank if it's waterlogged or incorrectly charged.
Why will my red lion RL-SWJ motor not start?
If your Red Lion Water Pump motor won't start, check the power supply and connections for blown fuses, open switches, or loose connections. Also, ensure the pump pressure switch is properly closed.
General| Series | RL-SWJ |
|---|---|
| Category | Water Pump |
| Brand | Red Lion |
| Type | Jet Pump |
| Horsepower | 1 HP |
| Voltage | 115V, 230V |
| Maximum Suction Lift | 25 feet |
Guidelines for joining PVC and metal pipe fittings, including methods and tips.
Details on pipe selection, slope, thread compound, and foot/check valve installation.
Steps for shallow well installations, covering drilled and driven wells with foot valves.
Steps for driven well installations using a check valve and well point.
Detailed steps for disassembling and reassembling to replace the mechanical seal.
