Red Sea MAX E Series User Manual

Red Sea MAX
®
E-Series
6
3 Unpacking the MAX
®
E System
Please read this section carefully before proceeding.
1. Remove the protective packaging from around the top of the tank.
2. Remove the components and any packaging materials that are packed
inside the aquarium.
3. Open the accessory box and remove all of the parts for later
assembly.
Removing the aquarium
With one person positioned at either side of the box, grasp the upper
rim of the aquarium and gently lift it out and place on the designated
surface.
CAUTION: The aquarium has a bare glass bottom. Before removing the
aquarium from the box prepare a smooth, soft, clean flat
surface that can hold its weight.
NOTE: Every precaution has been taken to ensure the safe arrival of
the MAX
®
E aquarium system, however before installing a new
glass aquarium it is advisable to inspect it for damage or leaks.
Place the aquarium in a suitable location and fill the tank and rear
sump to approximately 2.5cm (1”) below the top of the glass.
Leave the water standing for 15 minutes and inspect for leaks.
Syphon all of the water out before moving.
NOTE: Part of Cabinet is packed under the aquarium!
Approximate weights of Aquarium (empty)
Model Metric (kg) Imperial (lb)
E-170 25 55
E-260 40 90

Red Sea MAX E Series Specifications

General

Model	MAX E-170, MAX E-260
Skimmer	Included
Available Colors	Black, White
Integrated Power Center	Yes
Heater	Not included
Total System Volume	170 liters (45 gal), 260 liters (69 gal)
Display Tank Volume	Varies by model
Rear Sump Volume	Varies by model
Lighting	LED
Lighting Control	WiFi controlled ReefBeat app
Return Pump	2150 lph / 570 gph (MAX E-170), 2150 lph / 570 gph (MAX E-260)
Cabinet	Marine-Spec cabinet
Glass Thickness	12 mm (1/2")
Protein Skimmer	Included
Dimensions	57.5 cm x 57.5 cm x 142 cm / 22.6" x 22.6" x 56" (MAX E-170), 90 cm x 57.5 cm x 142 cm / 35.4" x 22.6" x 56" (MAX E-260)