Need help?Do you have a question about the Red Technology MAGIC-2 and is the answer not in the manual?
Warnings regarding damaged power cords or loose outlets and wet hands.
Warnings about installation environment and machine stability.
Identifies and explains the function of each part of the MAGIC-2 machine.
Outlines the steps for operating the engraving machine.
Instructions on how to fix materials using the vise.
Steps to enter calibration mode by pressing specific keys at power-on.
Detailed steps for performing probe calibration.
Step-by-step guide to calibrate the laser pointer.
Instructions for calibrating the vise center.
Guide on how to change the engraving tool using the T-Wrench.
Introduces the main interface and components of the MagicArt software.
General| Brand | Red Technology |
|---|---|
| Model | MAGIC-2 |
| Category | Engraver |
| Language | English |
To Next Page