2 INSTALLATION
2.3 Mounting the Remote Head
The Tow-Pro
™
Elite remote head is designed to be mounted at a distance from the main
unit, allowing for a neat, convenient installation and not impeding on lower leg airbags or
driver leg room. The Tow-Pro
™
Elite remote head is designed to be mounted on or around
the vehicle dashboard and when installed correctly, complies with Australian Design Rule
(ADR) 21, which sets requirements for devices mounted on the dashboard. The Tow-Pro
™
Elite remote head can be mounted directly to the dashboard, to the centre console or
through a spare knock-out switch panel and requires only two holes to be drilled as per
the below diagram.
Ensure the remote head push-button activates correctly when installed into surfaces with
a thickness greater than 3.0mm. Failure to activate correctly would result in not being
able to activate the override function or change modes.
8
Ø3.5mm
Ø10.0mm
(drill pilot
hole first
or use a
spade bit)
7.5mm
*2.0 - 3.0mm
Turn shaft fully
anti-clockwise
Apply knob with
‘0’ aligned with
the level marker
on the bezel.
Applying the Knob
Torque to 0.8Nm
To Next Page
Loading...
Need help?
General
