EasyManua.ls Logo

REDCAT Marksman - User Manual

REDCAT Marksman
55 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...

Table of Contents

Questions and Answers

  • T
    Tonya HarmonSep 10, 2025
    Why does my REDCAT Motorized Toy Car NiMH battery not last long?
    • T
      tammywardSep 12, 2025
      If the NiMH battery on your REDCAT Motorized Toy Car doesn't last as long as expected, there are a few potential reasons. First, ensure that the ESC (Electronic Speed Controller) is correctly set to NiMH battery mode. If it's set to LiPo, it can affect performance. You can consult the ESC Guide to make this adjustment. Second, the battery might not be fully charged. Use an appropriate NiMH charger to fully charge it. Finally, the battery itself might not be holding a charge, in which case, fully charge it using a suitable charger.
  • L
    luis73Sep 12, 2025
    Why is my REDCAT Motorized Toy Car making a grinding sound?
    • L
      Lisa FoxSep 12, 2025
      If you hear a grinding sound from your REDCAT Motorized Toy Car, it could be due to a couple of reasons. First, the gear mesh might be too loose; try resetting the gear mesh. Second, the gears might be worn, requiring you to replace them.
  • D
    Donald BurnsSep 14, 2025
    Why is my REDCAT Motorized Toy Car making a clicking noise while steering?
    • I
      ihunterSep 14, 2025
      If you hear a clicking noise while steering your REDCAT Motorized Toy Car, it could be due to a couple of reasons. First, the servo gears might be stripped, requiring you to replace the servo. Second, the servo horn might be stripped, requiring you to replace the servo horn.
  • R
    Ricardo FrazierSep 16, 2025
    Why is the RED LED flashing rapidly on my REDCAT Motorized Toy Car ESC?
    • P
      patrick01Sep 16, 2025
      If, after powering on the ESC of your REDCAT Motorized Toy Car, the Red LED flashes rapidly after detecting LiPo cells, the ESC may not be detecting a throttle signal. Check if the throttle wire is plugged in reversely or in the wrong channel, and ensure the transmitter is turned on. Another possibility is that the neutral throttle value stored on your ESC differs from the value stored on the transmitter. In this case, re-calibrate the throttle range after releasing the throttle trigger to the neutral position.

Summary

Warnings

START UP

INSTALL CONTROLLER BATTERIES

Install batteries into the RC vehicle's controller.

REMOVE BODY

Instructions for detaching the vehicle's body shell.

Power ON

INSTALL BODY

Procedure for mounting the vehicle's body onto the chassis.

BASIC RADIO CONTROLS

HOW TO STEER

Guidance on operating the steering function of the RC vehicle.

RADIO ADJUSTMENTS

Steering Trim - Steering Neutral

Adjusting the steering trim for a neutral steering position.

Throttle Trim - Throttle Neutral

Adjusting the throttle trim for a neutral throttle position.

Steering D;R - Maximum Steering

Adjusting the steering dual rate for maximum steering angle.

SHUT DOWN

REMOVE BODY

Procedure for detaching the vehicle's body shell.

Power Off

Steps to safely turn off the RC vehicle's power.

REMOVE BATTERY

Instructions for disconnecting and removing the battery pack.

RADIO GUIDE

Warnings and Compliance

Important safety and regulatory compliance information for the radio system.

WIRING DIAGRAM

Receiver Connections

Diagram showing how to connect the receiver to other components.

BINDING PROCESS

Steps involved in binding the transmitter to the receiver.

ESC GUIDE

ESC Connections

Diagram illustrating the connections for the Electronic Speed Controller (ESC).

ESC

LED Status Indicator

Explanation of the LED indicators on the ESC.

Restore the ESC to the default values

Procedure to reset the ESC settings to factory defaults.

Calibration

Steps for calibrating the ESC with the transmitter.

Programming

Instructions for programming various ESC settings.

ESC

Programming (Continued)

Further instructions for programming the ESC settings.

ESC

Programmable Items Description

Detailed explanations of the ESC's programmable features.

Program Card

Information on using the optional ESC programming card.

SLIPPER CLUTCH GUIDE

ADJUSTING THE SLIPPER CLUTCH

Instructions for adjusting the slipper clutch for optimal performance.

RECOMMENDED SLIPPER CLUTCH SETTINGS

Guidance on setting the slipper clutch to recommended levels.

SLIPPER CLUTCH ELIMINATION

Process for removing the slipper clutch from the vehicle.

INCLUDED ACCESSORIES

SPARE TIRE BRACKET

Instructions for assembling the spare tire bracket.

BONUS STICKERS

Information about included bonus stickers for customization.

TROUBLESHOOTING

FRONT AXLE

REAR AXLE

GEARBOX ASSEMBLIES

CHASSIS ASSEMBLY

BODY ASSEMBLY

BODY ASSEMBLY

REDCAT Marksman Specifications

General IconGeneral
BrandREDCAT
ModelMarksman
CategoryMotorized Toy Car
LanguageEnglish

Related product manuals