Page 6
Ceiling brackets safety test
After installing the ceiling brackets and before you start exercising in Redcord AXIS, you must
test the installation and load capacity.
Attach the Redcord rope lock to the rope as shown in the picture below. Lower the straps to
about 6 inches (15 cm) above floor level. Place one foot in both straps and try to bounce up and
down using your full body weight. Repeat the test on the other ceiling bracket. You have now
tested that each anchor point tolerates a load far exceeding your bodyweight. The ceiling
brackets are ready to use for training and treatment.
1
2
3
To Next Page
Loading...