Page 9
Safety test for Redcord AXIS and straps
Before you start exercising with Redcord AXIS you must ensure
that the apparatus is properly mounted.
1. Raise the straps all the way up.
2. Put one hand in each strap and lift your legs off the ground
so that your entire body is hanging from the apparatus.
3. Bounce your body to put additional load on the mounting.
You have now performed the safety test and the Redcord AXIS
is ready to use. If you have questions related to the mounting,
contact your local dealer.
Technical information,
IMPORTANT:
Seek professional advice about the condition of the ceiling prior to the installation of the device.
Redcord (nor its distributors) takes no responsibility for the suitability or condition of the ceiling in
which the equipment is installed.
Redcord takes no responsibility for any personal or physical damages that might arise due to
incorrect installation and/or incorrect use of Redcord equipment.
Redcord is not responsible for any personal or physical damage that might arise due to installation
or due to the ceiling.
Make sure that all screws are tightened well. The frequency of this routine depends on how much
the suspension is used, but we highly recommended that you perform a security check every week.
AXIS is made in conformity with essential requirements concerning
medical equipment (class I, rule 1) and is marked with CE mark.
The maximum load limit for Axis is 200 kg.
Maintainance for ceiling brackets
Grip the white ceiling brackets and try to move the brackets in vertically and horizontally
direction. The ceiling brackets should be stable in all directions.
Make sure that all 4 screws are tighten well for the two brackets. The frequency of this routine
depends on how much the suspension is used, but we highly recommend that you perform the
security check every week. Please document your security check.
To Next Page
Loading...