Redexim Verti-Drain 7521 - Replacing of a Crank and Crank Bearing; Removing the Crankshaft Tension; Alignment of an Element

18
15.2.2. REPLACEMENT OF A CRANK WITH BEARING.
Replacing a crank is necessary when it is cracked or when the big end nuts start to come loose on a regular
base. Either the crankbearing, the crankbearing fitting or the big end pin holes in the crank are damaged.
Replace the crank / bearing as soon as possible, to avoid any more damage to other parts, as follows:
1. Remove big end pin nuts IV (or II) from both big end pins connected to the crank.
2. Remove the big end pins, so that the big end can be swapped away. (Note; this will not happen with
the big end (pin) aside the gearbox.).
3. Remove the crank bearing covers III
4. Tap crank IV and bearing carefully side wards out of the frame by hitting the crank in the center
with a hammer.
5. Remove the bearing carefully from the crank.
6. After replacing the crank and/or bearing, replace the parts in the same sequence as they were
removed. Use loctite where indicated in fig.8.
7. If the crankshaft runs tight, see 15.2.3.
15.2.3 REMOVING THE CRANKSHAFT TENSION
.
If parts have been replaced on the crankshaft, the crankshaft may seem running tight. This is because of
possible tension in the crankshaft parts. It is necessary to remove these, as follows ,see fig.9.:
1. Tap the center of the crank adjacent to the gearbox, alternately left and right.
2. Feel whether the crank moves and continue till the crank has nested.
3. Repeat this operation with the adjacent crank and continue this way till the crankshaft will operate
more smoothly.
@ After any repair on the crankshaft, the crankshaft nuts should be checked regularly, see 12.0
@ Don’t assemble the cranks at the wrong side of the machine. See the spare part pages for the right
part numbers.
15.3 ALIGNMENT OF AN ELEMENT
.
In the event that an element is no longer in line with the adjacent elements, the alignment can be corrected as
follows (see fig.8.):
- Slacken the four bolts/nuts A, that connect the crankshaft to the element.
- Slacken the two bolts B, that fix the element to the main frame.
- Try to align the element by moving it side wards, till it ligns up with the adjacent ones.
- Start to tighten all bolts/nuts.
@ The element may be pushed out of line due to overload to the machine
@ When a crank is replaced, always re-align the element, so that no additional tension is created in
the total element assembly.
@ Any pre-tension in the element assembly will shorten the bearing life and may damage other parts
as well.