SELF HELP
If the shower is not working satisfactorily, make the following checks before calling out the installer.
Any one of these adjustments could restore the performance.
The shower temperature is set too hot causing the thermal cut-out
(safety device) to operate.
Turn Knob ‘B’ anti-clockwise to increase water flow.
Then slowly increase the water temperature by turning Knob ‘B’ clockwise
until a comfortable showering temperature has been reached.
You MUST WAIT approximately 20 seconds for each adjustment to affect
the water temperature.
‘ECO’ setting may need to be selected.
Increase water flow by adjusting Knob ‘B’ anti-clockwise.
‘ECO’ setting may need to be selected.
Increase pressure to water supply. Fully open service valve/stop cock.
Check hose is not kinked restricting the water flow.
Clean handset.
Check and clean filter if necessary.
Decrease water flow by adjusting Knob ‘B’ clockwise.
‘HIGH’ setting may need to be selected.
Water takes
longer to heat up
Thermal cut-out has operated after previous use
(automatically resets when unit cools down).
‘HIGH’ setting may need to be selected.
Check water pressure has not fallen so far as to let the pressure switch
cut out, e.g. another tap drawing water off.
Clean the shower handset.
Water continues
to flow when
button ‘C’ pressed
This is normal on the
Expressions Revive-Plus Models.
The shower includes a shutdown feature that means water will continue to
flow for around 6 seconds after Button ‘C’ is pressed.
Please contact our after sales service department (see page.17).
WHAT TO DO IF THINGS GO WRONG (1)
To Next Page
Loading...
Need help?
General
