10
Front swivel wheels
Fit the front swivel wheels by inserting them into the front wheel housing
located at the front of the frame. You will hear and feel a rm ‘click’ when
the wheels are locked in place.
Assembling the bassinet
Note: The Jive Bassient will come in a separate carton to your Jive pram.
1. Pull the three support rods located in the bottom of the bassinet into
place by following step 1A, 2A and 3A below. Once assembled correctly,
your bassinet will sit rigid and upright.
2. Assemble the bassinet lining on the bassinet frame.
3. Insert your bassinet mattress into the bottom of the bassinet snugly.
4. Secure your bassinet apron by using the press studs located on the
bassinet canopy.
TIP! You can open the apron using the zippers rather than unbuttoning
the apron from the canopy each time.
5. Secure the bassinet adaptors in the pram frame.
6. Click the bassinet into the adaptors. Check the bassinet is secured by
lifting it upwards when in the pram frame.
7. To remove, lift and release the locks on either side of the bassinet.
WARNING:
• Do not use bassinet once the child can sit up unaided.
• This bassinet is only approved for use with model Redsbaby Jive.
• The maximum weight of a child that can be carried in this bassinet: 9kgs.
1A 1B 1C
To Next Page
Loading...
