11
Assembling the seat and bumper
1. Take the seat unit fabric and stretch the head rest section over the top
of the circular frame and secure the Velcro tab located at the back.
2. Pull the rest of the seat unit fabric tightly towards the bottom of the
frame. Secure the seat unit fabric to the frame using the press studs
provided down the left and right hand sides of the circle frame.
3. Pull the foot rest upwards and secure the bottom of the seat unit fabric
over the foot rest and attach the Velcro tab located under the foot rest.
4. Attach the bumper by aligning the ends of the bumper with the two
openings on the circular frame. Gently push down into place until you
hear and feel a rm ‘click’ on both sides.
5. If desired, attach the canopy.
6. To place the seat on the frame, push down gently until you feel and
hear a rm ‘click’.
Basket
1. Secure the basket to the frame using the press studs provided.
2. Loop the webbing located at the rear of the basket around the frame,
and fasten using the press studs provided. Repeat using the webbing
located on the left and right sides of the basket by securing to the side of
the pram frame.
To remove, release all press studs.
WARNING:
• The weight limit of items in the shopping basket is 5kg.
• Do not exceed the weight limit. Overloading the shopping basket may
result in damage to the basket and your stroller.
WARNING:
• Do not use this seat with any other models of stroller.
• This seat is only approved for use with model: Redsbaby Jive.
• The maximum weight of a child that can be carried in this seat: 20kgs.
To Next Page
Loading...
