Redsbaby Jive - Using the 5-Point Safety Harness

14
Using the 5-point safety harness
WARNING:
• Use the harness at all times.
• When not in use disconnect shoulder straps from the waist strap and/
or buckle. The harness can form loops which may cause a strangulation
hazard. Never leave a harness connected when not tted to a child in the
Redsbaby Jive.
IMPORTANT: For the safety of your
child the 5-point safety harness must
be properly tted and adjusted. Follow
the instructions and Figure 1 below.
1. Ensure the seat is assembled correctly
by following steps on page 11.
2. Slide the shoulder strap clip (A1) onto
the waist strap clip (B1) and clip into the
center buckle (C).
3. Slide the shoulder strap clip (A2) onto
the waist strap clip (B2) and clip into the
center buckle (C)
Note: The shoulder heights can be
adjusted according to your child’s height
by feeding the shoulder straps through
the seat back. The shoulder straps
should sit just above the shoulders of
your child.
4. Adjust the shoulder strap (A1) and (A2), waist straps (B1) and (B2) and crotch
strap (D) to the desired t.
5. To unlock the 5-point safety harness, simply press the button in the middle of
the centre buckle (C) to release all straps at once.
Note: Padding has been provided for the shoulder straps (A1) and (A2) and
crotch strap (D) for the comfort of your child. The use of this padding is optional.
Figure 1
A1
A2
B1
B2
C
D