The result is a superior natual sound, an overall 3D sounding environment, especially if listened in
stereo. This is the next step in listening your effects. Stereo is the way to go.
NOTE
: While SEND section is stereo, only one I.R. can be loaded at a time, for both left and right outs.
SENDS will simply make a buffered copy for your right and left effect inputs, to be returned to stereo
RETURNS.
So, what is the advantage of sending the signal in stereo instead of using only one mono send and
then a stereo return?
Well, there are no advantages at all for a mono input device, besides the facts that some effects want
to see a stereo input signal to help make their algorithms work in the best way.
If you have a MONO input external device, use LEFT send to send a MONO signal.
If you want to use a MONO external device and only one jack/XLR out, use LEFT side first.
USB and HOW TO CONNECT THE AMP CENTRAL TO PC/MAC
You must connect Amp Central to your PC/MAC with a USB cable, to upload new I.R.'s by following
the next steps:
• Power off Amp Central by unplugging power connector on rear panel
• Connect a USB cable into AMP CENTRAL first and then your PC/MAC after.
• Amp Central will automatically be recognized as an external device (like your memory stick or
hard drive for example) with “AMPCENTRAL” name;
• Double click on it, and you’ll see folders with names from 0 to 3. By clicking on each folder,
you’ll find four more folders, each one with an I.R. inside. This means a total of 16 files/folders
are available, divided into four banks with four cabinets in each bank.
•
UPDATE: From unit with s/n 23037 and higher, bank are numbered from 1 to 4 and not 0
to 3. It does not change anything in practical life, but if can be confusing.
To Next Page
