Reebok 1000 X Elliptical - Page 10

10
10. Orient a Pedal (26) as shown. Attach the Pedal
to the bracket on the Left Pedal Leg (24) with
two M8 x 55mm Patch Screws (89) and two M8
Hex Nylon Locknuts (80).
Repeat this step to attach the other Pedal
(26).
10
25
25
77
100
27
9
9. Insert the axle of the Roller (27) through the
right Link Arm (25); make sure that the Roller
is on the inner side of the Link Arm. Attach
t
he Roller with an M10 x 15mm Patch Screw
(77) and an M10 x 22mm x 1.5mm Washer
(
100). Tip: Use a wrench to hold the axle of
the Roller firmly in place while you tighten
the Patch Screw into the axle.
Repeat this step to attach the other Roller
(not shown) to the left Link Arm (25).
24
89
26
26
80