1.
Remove the two M10 x 120mm Patch Screws
(78) and the shipping bracket (not shown)
attached to the front of the Frame. Discard the
shipping bracket. Do not discard the two M10 x
120mm Patch Screws.
Orient the Front Stabilizer (49) with the Wheels
(8) in the position shown. While a second per-
son tips the Frame (1) backward, attach the
Front Stabilizer to the Frame with the two M10 x
120mm Patch Screws (78).
6
2. Identify the Right Handlebar (36), which is
marked with an “R” sticker. Attach the Right
Handlebar to the Frame (1) with the Upper Body
Endcap (34) and three M6 x 18mm Patch
Screws (108).
Repeat this step for the other side of the
elliptical exerciser.
78
49
1
2
1
1
8
8
108
36
34
To make assembly easier, read the
information on page 5 before you begin
a
ssembling the elliptical exerciser.
To Next Page
Loading...
