Introduction
Thank you for purchasing your REED R5600 Insulation Tester. Please
read the following instructions carefully before using your instrument. By
following the steps outlined in this manual your meter will provide years of
reliable service.
Product Quality
This product has been manufactured in an ISO9001 facility and has been
calibrated during the manufacturing process to meet stated product
specications. If a certicate of calibration is required please contact the
nearest authorized REED distributor or authorized Service Center. Please
note an additional fee for this service will apply.
Safety
• Never attempt to repair or modify your instrument. Dismantling your
product, other than for the purpose of replacing batteries, may cause
damage that will not be covered under the manufacturer's warranty.
Servicing should only be provided by an authorized service center.
• Do not use the meter or test leads if they look damaged. Use extreme
caution when working around bare conductors or bus bars as
accidental contact with conductors could result in electric shock.
• Use the meter only as specied in this manual; otherwise, the protection
provided by the meter may be impaired.
• Use caution when working near voltages above 60V DC or 30V AC
RMS. as such voltages pose a shock hazard.
• Circuits being tested must be de-energized and isolated before
connections are made (This does not apply for voltage measurements).
continued...
3
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
To Next Page
Loading...
Need help?
General
