Reed Instruments R8080 User Manual

9
Setting the Datalogging Recording Interval
In order to set the sampling rate on the meter, follow steps 1 through 4.
1. While the meter is off, enter the Setup mode by pressing and holding
the Power Button and A/C buttons simultaneously. "Set" will ash on
the display indicating you are in the Setup mode.
2. Press the FAsT/slOw(INTV)buttontoenterRecordingInterval
setup screen as indicated by "Int".
3. PresstheUpandDownarrowstoadjusttherecordinginterval.A
maximumvalueof1minuteandminimumvalueof1secondcan
be set.
4. Press the FAsT/slOw(INTV)buttontosavethedesiredsampling
rate and resume normal operation.
NOTE:PressthePowerbuttontoexitSetupmodeatanytime.
Datalogging
1. Turn the meter on and select your desired sampling rate
(See"SettingtheDataloggingRecordingInterval"above).
2. Press the REC button to begin datalogging.
3. Press the REC button again to stop datalogging.
Clearing Stored Data
To delete internal memory press and hold the REC button and Power
button simultaneously for 5 seconds when the meter is off. The display
will show a 5 second countdown. Once the countdown is completed
"Clear" will display conrming the memory has been erased.
Calibration Procedure
continued...
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com

Reed Instruments R8080 Specifications

General

Brand	Reed Instruments
Model	R8080
Category	Measuring Instruments
Language	English