39
6. Safety instructions
The guarantee/warranty will be void if damage is incurred resulting from non-compliance with the
operating instructions. Liability for any and all consequential damage is excluded!
We do not assume any liability for damage to property or personal injury caused by improper use
or the failure to observe the safety instructions! In such cases the guarantee is voided.
Normal wear and tear and accidents or damages caused by a crash (e.g. broken propeller or parts of the
plane) are excluded from the guarantee and warrantee.
Dear Customer,
these safety instructions are not only for the protection of the product but also for your own safety and that
of other people. This is why you should read this section very carefully before using the product!
a) General information
Attention important notice!
Operating the model may cause damage to assets and/or persons. Therefore, you have to make sure that
you have sufficient insurance cover when operating the model, e.g. liability insurance. If you already have
a liability insurance, please inform yourself before using the model whether this is insured as well.
Please note: Insurance for all flight models is mandatory in different EU countries!
• The unauthorized conversion and/or modification of the product or its components is inadmissible because of safety
and approval reasons (CE).
• The product is not a toy and should be kept out of reach of children under 14 years of age!
• The product must not get damp or wet.
• If you do not have sufficient knowledge yet as how to deal with remote-controlled helicopters, please seek the advice
of an experienced model sportsman or a model construction club.
• Do not leave packaging material unattended. It may become dangerous playing material for children!
• Should questions arise that are not answered with the help of this operating manual, contact us (contact information
see chapter 1) or another expert.
b) Before operation
• Unroll the antenna wire of the receiver of the model to its complete length. Install the antenna in such a way that the
antenna wire cannot get caught in rotating parts! The antenna wire may not be rolled up or clipped.
• Make sure that no other models are operated within the range of the remote control on the same remote control
channel (transmitter frequency). Otherwise, you will lose control over the remote-controlled model! Always use
different channels if you wish to operate simultaneously two or several models in the immediate proximity of each
other.
• Regularly check the function safety of your model and of the remote control system. Pay attention to visible damages
such as broken plug-in connections or damaged cables. All movable parts on the model have to be smooth running;
however, there must be no tolerance in the bearing.
To Next Page
Loading...