63
a) Deinstalling the mechanics
For maintenance work or repairs, you may have to dissemble/deinstall the mechanics of the helicopter. Proceed in the
following sequence:
• Remove the attachment on the tail of the fuselage.
• Remove the screw of the rotor blade retainer (1) located
above the grub screw (2) of the blade holder (ill. 19).
• Remove the attachment screw of the tail rotor control lever
(3) and unhook the control lever (ill. 20).
• Detach the grub screw (ill. 19, pos. 2) of the blade holder
and pull the free-wheel as well as the blade holder from
the shaft.
• Remove the six attachment screws (4) of the tail rotor drive
(ill. 21).
Ill. 19
Ill. 21
Ill. 20
To Next Page
Loading...