EasyManuals Logo

Reflex Exvoid A 60.3 User Manual

Reflex Exvoid A 60.3
Go to English
217 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
reflex Safety
Reflex ex separator English 3
1.3
1.2 Personnel requirements
Only specialist personnel or specifically trained personnel may install and operate the equipment.
Notes to personnel
Notice!
Every person installing this equipment or performing any other work at the equipment is required to carefully read this
operating manual prior to commencing work and to comply with its instructions. The manual is to be provided to the product
operator and must be stored near the product for access at any time.
Modifications of the equipment are not permitted.
For example, welding at other points than the connection piece (in equipment with welded connection)
For example, mechanical deformations
Use only original parts provided by the manufacturer when replacing parts.
All required inspections must be ordered by the operator pursuant to the provisions of the applicable industrial safety regulations.
Required inspections and tests are:
Inspections and tests prior to commissioning
Inspections and tests after significant modifications of the installation
Recurring inspections
The devices to be installed and operated must not exhibit any visible exterior damage at the pressure component.
Ignoring this manual and the safety information in particular, may cause the destruction and defects of the equipment, endanger
persons and adversely affect the functioning. Any contravention voids the guarantee and liability.
1.4 Intended use
The devices are manufactured from steel with exterior coating; the interior is uncoated. The devices may be used only in systems that
are sealed against corrosion and with the following water types:
Non-corrosive
Chemically non-aggressive
Non-toxic
The ingress of atmospheric oxygen by permeation into the entire heating and cooling water system, make-up water and similar must be
reliably minimised during operation.
1.5 Inadmissible operating conditions
The devices are not suited for the following conditions.
In drinking water systems
For outdoors operation
For the use with mineral oils
For the use with flammable media
For the use with distilled water

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Reflex Exvoid A 60.3 and is the answer not in the manual?

Reflex Exvoid A 60.3 Specifications

General IconGeneral
BrandReflex
ModelExvoid A 60.3
CategoryWater Filtration Systems
LanguageEnglish

Related product manuals