REFUSOL 20K-2T - Setting Parameters

REFUsol 20K-2T (853P020.200)
User manual
- 44 -
(A)Enter setting Interface as below
：
1.Enter Setting
--------Long press DOWN button
1.Set Time
13.PCC Select
2.Clear Energy
14.Reflux Mode
3.Clear Events
15.OVP
4.Set SaftCode
16.Power Limit
5.On-Off Control
17.ReactivePara
6.Set Energy
18.Hard Reflux
7.Set ComProtocol
19.Set Insulation
8.Set Input mode
20.PELineControl
9.Set Language
21.InputSafety
10.Set AntiReflux
22.Set Safety
11.Logic Interface
23.Autotest Fast
12.IV Curve Scan
24.Autotest STD
Long press the button to Enter the main interface of "1. Enter Setting" and
long press to enter the setting menu. You can select the content you want to set by
short pressing the button.
Note1: Some settings need to enter the password (the default password is
0001), when entering the password, short press to change the number, long press
to confirm the current number, and long press after entering the correct password.
If "password error, try again" appears, you will need to re-enter the correct
password.
1. Set Time
Set the system time for the inverter.
2. Clear Energy
Clean the inverter of the total power generation.
3. Clear Events
Clean up the historical events recorded in the inverter.
4. Set SaftCode
Long press button, enter interface, save the specific file into USB and insert USB