www.rega.co.ukEN
LOUDSPEAKER ASSEMBLY
(21)
and four Pozi No. 2 screws. These are required
(Fig. A)
up on to a level surface before fully tightening
position (Fig. B).
IMPORTANT: NEVER place the speaker face
the drive units.
CONNECTION
Ensure the colour terminals Red (+) and Black
(-) are connected to the correct terminals at
POSITIONING
can be tuned by adjusting the distance of
the speaker from the rear wall. As with all
loudspeakers, this will be dependent on the
distances will help optimise the performance
to your surroundings. In general, more bass is
produced if the cabinet is positioned closer to a
structural wall.
KYTE STAND ADAPTOR
An optional metal base is available for
with a wide range of third party loudspeaker
REPLACING THE DRIVE
UNITS
In the unlikely event a drive unit needs to be
replaced, it is necessary to remove the front
screws. A new adhesive front panel label will
be supplied as standard with any replacement
units. To remove the front panel label, we
recommend accessing via the unit that requires
replacement to prevent damage to the phenolic
cabinet. We recommend that any servicing is
carried out via a registered Rega dealer, you
co.uk/dealers.
x4 (SUPPLIED)
FIG. A FIG. B
MOVE ON TO
FLAT SURFACE
BEFORE FULLY
TIGHTENING
x2 (SUPPLIED)
21
To Next Page
Loading...
