Equipment Operation
6-1
!
TO PREVENT VESSEL FROM SINKING,
INSTALL DRAIN PLUG!
Drain Plug
This chapter assists the operator in understanding the equipment
installed on the vessel. Some of the equipment described may not be
installed on your boat or the pictorials may not exactly resemble your
equipment. Regal is constantly improving its product line and therefore
may make changes in parts and specifications without notice. For
detailed equipment information,, also refer to the individual vendor
literature in the owner’s pouch.
Your boat is equipped with a
garboard style drain plug. Make sure
it is installed tightly before launching.
Tighten with a wrench. Do not use your
fingers alone to tighten it. After your
outing while the boat is angled on
the ramp remove the drain plug to
eliminate any bilge water
accumulation. If the water stream is diminished, check for foreign
objects stuck in the drain hole. Pull the drain plug if dry storing the
boat for extended periods especially in colder climates.
TIGHTEN-CLOCKWISE
To Next Page
Loading...
