Equipment Operation
6-59
Berth Set-up
On 2750 models, the berth cushions can be
set up into a sleeper.
Start by inserting the 3 cushion support bars
in the built-in berth support brackets. All bars
are different lengths and fit one-way only. Make
sure all 3 bars are seated.
Next, remove the port or starboard backrests.
Install them as shown in the illustrations. The
port backrest cushion fits in the starboard
postion as shown.
The starboard backrest cushion fits in the port
position as shown. Be sure both backrests are
set securely in place. Reverse the process to
disassemble the berth.
Short Bar To Bow
To Next Page
Loading...
