CHAPTER 6
6-64
The optional cockpit cover installs over the windshield and snaps to the
deck. To install the cockpit cover, note that on the bow end of the
cover there is a seam on the inside which separates the port and
starboard sides. Align this seam with the center snap below the
windshield. Complete snapping the canvas to the outside and then
down each gunnel to admidships. Your boat may use several cockpit
poles. Their purpose is to keep the canvas tight and water out of the
interior. Notice on the underside of the cover there are areas of
reinforced canvas material. These are for the cockpit cover poles. Each
pole is adjustable by opening it to the desired length and tightening
the thumb screw. You may find it helpful to mark the poles so you can
install the poles in the same spot each time. Continue to snap the
cockpit cover to the deck snaps. When you reach the rear corner leave
enough room to allow a safe exit at the swim platform.
2700 BIMINI TOP W/ BOWS
Cockpit Cover
To Next Page
Loading...
