To Next PageTo Next Page
Need help?Do you have a question about the Regency Fireplace Products E18 and is the answer not in the manual?
General| Type | Electric Fireplace |
|---|---|
| Model | E18 |
| Category | Indoor Fireplace |
| Fuel Type | Electric |
| Heating Area (sq. ft.) | 400 |
| Voltage | 120V |
| Remote Control | Yes |
| Thermostat | Yes |
| Power Consumption | 1500W |
| Safety Features | Overheat Protection |
Crucial safety steps to follow when detecting gas, emphasizing immediate action and avoiding ignition sources.
Direct warning about the danger of hot glass and the need to prevent contact, especially by children.
Detailed measurements of the fireplace unit for installation planning and fitting.
Specifies the required distances from combustible materials around the fireplace for safe operation.
Outlines essential safety practices and compliance requirements before commencing installation.
Key technical specifications for the appliance, including altitude and orifice sizes.
Details on making the gas line connection and ensuring proper and safe gas supply.
Specifies the minimum size requirements for the fireplace opening to accommodate the insert.
Guidelines for proper venting setup for different installation scenarios, including zero clearance.
Lists the essential tools recommended for performing the installation correctly.
Instructions for connecting the vent using Type A configuration.
Instructions for connecting the vent using Type B configuration.
Steps for installing the main firebox component into the outer shell or existing structure.
Guidance on installing the log tray and its components.
Instructions for replacing the safety screen on the glass door.
Steps for installing a wall switch to control the fireplace operation.
Explanation of the safety switches that monitor and control the appliance's operation.
Step-by-step guide on how to safely light the fireplace pilot and main burner.
Specific instructions for lighting the appliance as found on the unit's lighting plate.
Guidance on safely removing and replacing logs for maintenance or aesthetic reasons.
Procedures for safely removing and installing the gas control valve.
Section for the installer to record details of the installation and the unit.
