Regency ULTIMATE U41FS-LP - Operating Instructions

OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Before operating this appliance, proceed through the
following check list.
1) Read and understand these Instructions before
operating this appliance.
2) Check to see that all wiring is correct and en¬
closed to prevent possible shock.
3) Check to ensure there are no gas leaks.
6) Push in control knob all the way and hold in.
Immediately push red button on spark igniter
until pilot lights. Continue to hold the control
knob in for approximately one minute, then
release the gas control knob. The pilot flame
should continue to bum. If the pilot does not
remain lit, repeat operation allowing a longer
period before releasing gas control knob.
7) Turn gas control knob counterclockwise to "ON”.
8) Use rocker switch to operate main burner.
4) Make sure the three pieces of door glass are
properly positioned. Never operate the appliance
with any of the glass removed or with the door
open.
5) Verify that all venting and the cap is unobstructed.
6) Verify log placement. If the pilot cannot be seen
when lighting the unit - the logs or the embers
have been incorrectly positioned.
7) The unit should never to turned off and on without
a minimum of a 60 second wait.
LIGHTING PROCEDURE
9) R otate the variable flame control to adjust the
flame height higher or lower.
10) T he door must be closed when operating the
unit.
OFF
IMPORTANT: Gas cock knob cannot be turned
from "PILOT to "OFF" unless It is partially
depressed.
SHUTDOWN PROCEDURE
1) U se the rocker switch to turn off the main burner.
1) Open the door when lighting the pilot, but once
the pilot is lit, DO NOT operate the unit with the
door open.
2) If the control knob is in the "OFP position pro¬
ceed to Step 4.
3) Push in gas control knob slightly and turn clock¬
wise to "OFF". Knob cannot be turned from
"PILOT to "OFF" unless knob is pushed in
slightly. .Do not f<yoe.- •- •;, -
4) Wait five minutes to aliow gasrthat may have
accumulated in the main burner compartment, to
escape. If you do smell gas, follow the instructions
on the front of this manual. If you don't smell gas
continue on to the next step.
5) Turn the gas control counterclockwise to "PILOT.
2) Push in the gas control knob slightly and turn
clockwise to "OFP. Do not force.
3) Turn off all electric power to the appliance if
service is to be performed.
FIRST FIRE
The first fire in your stove is part of the paint curing
process. To ensure that the paint is properly cured,
fight theunit and leave it oh for 5 minutes and let it —
cool down for 30 minutes. Repeat 3 or 4 times. When
first operated, the unit will release an odour caused by
the curing of the paint, the burning off of any oils
: remaining from manufacturing and burning off the
starch in the gas logs.
The glass panel will require cleaning after the unit has
cooled down. DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS HOT.
Regency ULTIMATE Freestanding Gas Heater
13