Regency ULTIMATE U41FS-LP - Lighting Instructions; Copy of Lighting Plate Instructions

OPERATING INSTRUCTIONS
Copy of the Lighting Plate instructions
££££££ FOR YOUR SAFETY READ BEFORE LIGHTING
This appliance must be Installed In accordance with local codes, If any; If not, follow
the current CAN1-B149/ANSIZ 223.1-1988__
WARNING: If you do not follow these Instructions exactly, a fire or explosion may result
causing property damage, personal Injury or loss of life. Improper installation, adjust¬
ment, alteration, service or maintenance can cause Injury or property damage. Refer to
the owner’s information manual provided with this appliance. For assistance or addi¬
tional information consult a qualified installer, service agency or gas supplier.
A) This appliance has a pilot which must be lighted by
hand, following the Instructions below exactly.
B) BEFORELIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
- Do not try to light any appliance
. Do not touch any electric switch, do not use any
phone in your building
- immediately call your gas supplier from a neighbours
phone. Follow the gas supplier*© instructions.
- If you cannot rsach your gas supplier, call the Are
department
C) U se only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair It, call a qual ified service
technician. Force or attempted repair may result in a fire
or explosion.
D)Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
underwater.
This appliance needs fresh airfor safe operation and must
be installed so there are provisions for adequate combus¬
tion and ventilation air.
CAUTION: Hot while in operation. Do not
| touch. Due to high surface temperatures
keep children, clothing and furniture, away
Keep burner and control compartment
clean. See installation and operating in¬
structions accompanying appliance.
LIGHTING INSTRUCTIONS
STOP! Read the safety information above on this label.
1) Push in gas control knob slightly and turn clockwise **
to “OFF*. Knob cannot be turned from “PILOT” to
“OFF* unless knob Is pushed In slightly. Do not force.
2) Wait five (5) minutes to clear out any gas. If you then
smell gas STOP! follow “B” in the safety information
above on this label. If you don’t smell gas, go to the next
step.
3) Turn knob on gas control counterclockwise ^ to
“PILOT’.
4) Push in control knob all the way and hold in. Immedi¬
ately push red button on spark igniter until pilot lights.
Continue to hold the control knob in for about 1/2
minute after the pilot is lit Release knob and it will pop
back up. Pilot should remain lit. ff it goes out, repeat
8tep83)and4). , r . y* »• • •
If knob does not pop up when released, stop and
* immediately call your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas
control knob to “OFF* and call your service technician or
gas supplier.
5) Turn gas control knob counterclockwise ^ to
ON”.
6) Use rocker switch to operate main burner.
PILOT BURNER THERMOPILE
VEILLEUSE j -1
J I I ELEMENT
THERMO-
ELECTRIQUE L_| ~ A
TO TURN OFF GAS APPLIANCE
1) Push In the gas control knob slightly and turn
clockwise to “OFF*. Do not force.
2) Turn off alielectric power to the appliance If service Is to
be performed._
DO NOT REMOVE THIS INSTRUCTION PLATE
908-401
14
Regency ULTIMATE Freestanding Gas Heater