Regency ULTIMATE U41FS-LP - Maintenance; Maintenance Instructions

MAINTENANCE
AUTOMATIC CONVECTION FAN
OPERATION
The fan operates automatically, push the rocker
switch on the side of the pedestal to either "HIGH" or
"LOW" for fan speed. The fan will turn on as the stove
comes up to operating temperature. After the unit has
been turned off and the unit cooled to below a useful
heat output range the fan will shut off automatically.
MAINTENANCE INSTRUCTIONS
1) Always turn off the valve before cleaning. For re¬
lighting, refer to lighting instructions. Keep the
burner and control compartment clean by brush¬
ing and vacuuming at least once a year.
When cleaning the logs, use a soft clean paint
brush as the logs are fragile and easily damaged.
2) Clean glass (never when unit is hot), appliance,
louvers and door with a damp cloth. Never use an
abrasive cleaner. The gold louvers (and optional
gold door) may be scratched if abrasives are used
to clean them.
The heater is finished in a heat resistant paint and
should only be refinished with heat resistant paint
(not with wall paint). Regency uses Stove Brite
Paint - Metallic Black #6309.
3) Make a periodic check of burner for proper
position and condition. Visually check the flame of
the burner periodically, making sure the flames
are steady; not lifting or floating. If there is a
problem, call a qualified service person.
4) The appliance and venting system must be
inspected before use, and at least annually, by a
qualified field service person, to ensure that the
flow of combustion and ventilation air is not
obstructed.
During the annual service call, the burners should
be removed from the burner tray and cleaned.
Use' the remaining embers that were saved during
the installation to replace especially dirty or
fragmented embers. Do not block the pilot.
WARNING: CHILDREN AND ADULTS SHOULD
BE ALERTED TO THE HAZARDS OF HIGH
SURFACE TEMPERATURE AND SHOULD STAY
AWAY TO AVOID BURNS OR CLOTHING IGNI¬
TION. YOUNG CHILDREN SHOULD BE CARE¬
FULLY SUPERVISED WHEN THEY ARE IN THE
SAME ROOM AS THE APPLIANCE.
CAUTION: ANY SAFETY SCREEN OR GUARD
REMOVED FOR SERVICING AN APPLIANCE
MUST BE REPLACED PRIOR TO OPERATING
THE APPLIANCE.
CLOTHING OR OTHER FLAMMABLE MATERIAL
SHOULD NOT BE PLACED ON OR NEAR THE
APPLIANCE.
6) Each time the appliance is lit, it may cause con¬
densation and fog the glass. This condensation
and fog is normal and will disappear in a few
minutes as the glass heats up.
Never operate the appliance without the glass
properly secured in place or with the door
open.
7) Periodically check the pilot flames, there should
be three strong blue flames approx. 1/2" long -1
flame to the front burner, 1 to the rear burner and
1 to the thermopile. See diagrams below.
If you have an incorrect flame pattern, contact
your Regency dealer for further instructions.
Correct flame pattern has three strong blue
flames: 1 flowing around the thermopile and
ignitor electrode, 1 flowing across the rear
burner and 1 reaching towards the front
burner (it does not have to be touching the
burner).
Rear Burner
- i -
1 /2* *|° ^^^^ ^afeblslalslgblgk
,Thermopile
gap of 1/8"
Ignitor Electrode
5) K eep the area near the appliance clear and free
from combustible materials, gasoline and other
flammable vapours and liquids.
. 4 . .
Front Burner
Top View of pilot flame.
Regency ULTIMATE Freestanding Gas Heater
15