Form: 640188 TS-9
Monitors power - up (screens light,
green LED on rear panel is on) but
no video is displayed; all
monitors.
VCP not operated properly Verify that a known good VHS tape
has been inserted and that the VCP is
in play. PLAY LED, on the front of
VCP, is illuminated. VCP may be
put into play from either the Control
Head or directly from the front panel
of the VCP.
VCP Video out connection
defective or incorrect.
Check Video Out connection, at the
rear of the VCP. Connection should
be made to the jack labeled VIDEO
OUT.
If possible, remove VCP and check
out the unit by connecting it directly
into a monitor with a Video input. If
unit does not function, repair or
replace it. If unit operates, check the
cable, in the coach, that connects to
the Video Out. Repair or replace as
necessary.
Defective or improperly
installed Video Distribution
Amplifier (700459) * May
not be installed on all
systems.
Verify that the Distribution Amp has
power connected to it. Verify that it
is connected to the Video Out cable,
from the rear of the VCP. Verify
that the individual coax cables are
correctly plugged into it. If there still
is no video present at the monitors
(and the VCP is operational) repair
or replace the Video Distribution
Amp (700459).
To Next Page
Loading...
