REITER AGR-08-E - Maintenance; Possible sources of error for the reassembly

S-AGR08-Egb08 05/15 - 3 Page 10 of 15
8 Maintenance
8.4.1 Possible sources of error for the reassembly
 Mounttwogaskets(6)withairdistributingring
(7).
Essential to maintain correct position and
seat!
Insert the respective smaller diameter of
the gaskets into the air distribution ring.
Here the lower gasket is slipped!
A visual check is necessary!
 Greasenozzle(4)andtightenwith30Nm.
Pay particular attention to the pretension of
thegaskets(6).Placethepaintnozzlemanu-
ally. Then tighten with a torque wrench to 30
Nm.
 Usealwaysanutorsocketwrenchtotighten,
otherwisethenozzlecanbedeformed.
Under no circumstances use a wrench!
Attention: Ensure correct t!
Place retaining ring and tighten by hand.
 Checkannulargapbetweenthepaintnozzle
(4)andaircap(3)visuallyonroundconsistent
measure.
 Asillustratedontheleft,itmaynotlooklike!
 Checkproperseatingoftheaircapvisually!