Reliance 520 - Technical Specifications

WARNING: TO PREVENT FIRE OR
ELECTRICAL SHOCK HAZARD, DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR
MOISTURE.
AVERTISSEMENT : POUR ÉVITER UN
INCENDIE OU UN RISQUE DE CHOC
ÉLECTRIQUE, N’EXPOSEZ PAS CET
ÉQUIPEMENT À LA PLUIE OU À L’HUMIDITÉ.
TECHNICAL SPECIFICATIONS
Rating for 120V Low Voltage Chair
This equipment is rated Class I, Type B
Equipment Model
Low Voltage Chair 520
Volts Hertz Amps
120V 50/60 6.3
Class I Type B
Rating for 220-240V Low Voltage Chair
This equipment is rated Class I, Type B
Equipment Model
Low Voltage Chair 520
Volts Hertz Amps
220-240V 50/60 4.0
Class I Type B
IMPORTANT USER WARNINGS
WARNING: EXPLOSION HAZARD. THIS
EQUIPMENT MUST NOT BE USED IN THE
PRESENCE OF FLAMMABLE ANESTHETICS.
AVERTISSEMENT : RISQUE D’EXPLOSION.
CET ÉQUIPEMENT NE DOIT PAS ÊTRE
UTILISÉ EN PRÉSENCE D’ANESTHÉSIQUES
INFLAMMABLES.
POTENTIAL ELECTROMAGNETIC or OTHER
INTERFERENCE
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to other devices
in the vicinity. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to other
devices, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving device.
• Increase the separation between the equipment.
• Connect the equipment into an outlet on a circuit different
from that to which the other device(s) are connected.
• Consult the manufacturer or eld service technician for
help.
WARNING - STORAGE OF THIS EQUIPMENT
BELOW 40°F (4.4ºC) WILL CAUSE THE
HYDRAULIC OIL TO BECOME THICK. THIS
MAY CAUSE UNUSUAL NOISES WHEN
THE BASE MOTOR IS OPERATED. IT IS
RECOMMENDED THAT THE EQUIPMENT
STAY AT A TEMPERATURE OF 60°F (15.6ºC)
OR ABOVE FOR AT LEAST 8 HOURS BEFORE
OPERATING.
AVERTISSEMENT : L’ENTREPOSAGE DE
CET ÉQUIPEMENT À MOINS DE 4,4°C
(40°F) FERA EN SORTE QUE L’HUILE
HYDRAULIQUE DEVIENDRA ÉPAISSE.
CECI POURRAIT CAUSER DES BRUITS
INHABITUELS LORSQUE LE MOTEUR DE LA
BASE FONCTIONNE. ON RECOMMANDE
QUE L’ÉQUIPEMENT DEMEURE À UNE
TEMPÉRATURE DE 15,6°C (60°F) OU PLUS
DURANT AU MOINS 8 HEURES AVANT DE
L’UTILISER.
IN-5206