CAUTION!
The Dynamometer 04 is an instrument for the measurement of forces of traction. The use of it
requires the knowledge of the specifications instrument and observance of the safety regulations.
Read this manual before working with the Dynamometer 04. Don’t give the instrument to people who
don’t know how to follow the instructions.
- Never subject the Dynamometer 04 to loads which are higher than the maximum capacity marked on
the instrument.
- The instrument is made to work only with forces of traction applied lengthwise; never subject the
Dynamometer 04 to torsional or bending stress, or to compression loads.
- Use anchorage and application loads systems of appropriate resistance with a security grade higher
than 5 and always test the strength.
- Protect the instrument from knock or falls, especially on the display.
- For repairs or substitutions, apply only to the manufacturer or distributor of the
Instrument.
- Don’t modify the instrument with mechanical works.
- Don’t make any arc - welding with the Dynamometer 04 connected on the mass- circuit.
- Don’t use the Dynamometer 04 on lines which involve the lifting of people.
- The Dynamometer 04 can’t be used in any explosive atmosphere.
REMA HOLLAND BV declines all responsibility for the consequence of an illegitimate use of the
Dynamometer 04 or of alterations and or manipulations of it.
To Next Page
Loading...
Need help?
General