11 91679
MAINTENANCE
The following dispenser maintenance should be performed at the intervals indicated:
DAILY or as required
Remove foreign material from the vending area sink to prevent drain blockage.
WEEKLY or as required
Clean vending area. Check for proper water drainage from the vending area sink.
MONTHLY
Clean and sanitize the hopper interior (see CLEANING INSTRUCTIONS).
START-UP AND OPERATING INSTRUCTIONS
Fill the hopper with ice. For “ BC” models with a built-in cold plate, dispense several large cups of ice (approxi-
mately 20 to 30 seconds total dispensing time) to allow ice to fill the cold plate. Add ice to the hopper as neces-
sary to refill then replace the lid. Allow 10 to 15 minutes for the cold plate to cool down. Repeat this procedure
whenever the dispenser has been standing overnight or other long periods without ice use. On “B” and “ BC”
models start up the beverage system and adjust faucets to the proper brix. Contact your local distributor for
complete information on the beverage system.
In normal operation, pushing the ice dispenser lever will cause ice to flow from the ice chute. Ice flow will contin-
ue until the lever is released. Pushing the lever on any faucet will provide beverage of the appropriate flavor.
For automatic ice filling “K” models, the agitation timer causes the ice to level which allows the entire storage bin
to fill before the ice machine shuts off. The icemaker control capillary bulb maintains the ice level in the storage
hopper. Consult the instructions provided with the installation kit and the icemaker manual for location and op-
eration of the icemaker control.
CAUTION: Use caution to avoid spilling ice when filling dispenser. Immediately clean up
any spilled ice from filling or operation of the unit. To prevent contamination of ice, the lid
must be installed on the unit at all times.
CLEANING INSTRUCTIONS
WARNING: DISCONNECT POWER BEFORE CLEANING! Do not use metal scrapers, sharp
objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage
may result. Do not use solvents or other cleaning agents, as they may damage the plastic
material.
DISPENSER All Models
1. Clean the ice storage hopper at least once a month.
To Next Page
Loading...