REMKO Easy-Control EC1 - Block Programming Day 1-5

To set or change the switching times and room temperature, proceed as follows:
Programming Parameter Unit
Press
1 x
Actual time Minutes
Press
2 x
Actual time Hours
Press
3 x
Actual day of the week 1-7 (Monday-Sunday)
Block programming day 1-5 (Monday-Friday)
Programming Parameter Unit
Press 4 x
Switching time 1 time Minutes
Press 5 x
Switching time 1 time Hours
Press
6 x
Switching time 1 temperature Room target temperature
Press
7 x
Switching time 2 time Minutes
Press 8 x
Switching time 2 time Hours
Press
9 x
Switching time 2 temperature Room target temperature
Press 10 x
Switching time 3 time Minutes
Press
11 x
Switching time 3 time Hours
Press 12 x
Switching time 3 temperature Room target temperature
Press
13 x
Switching time 4 time Minutes
Press 14 x
Switching time 4 time Hours
Press
15 x
Switching time 4 temperature Room target temperature
Press
16 x
Switching time 5 time Minutes
Press 17 x
Switching time 5 time Hours
Press
18 x
Switching time 5 temperature Room target temperature
Press 19 x
Switching time 6 time Minutes
Press
20 x
Switching time 6 time Hours
Press
21 x
Switching time 6 temperature Room target temperature
If the power to the remote control is switched off, the time must be reset.
The parameter settings are retained.
11