EasyManuals Logo

REMKO RKL DC Series User Manual

REMKO RKL DC Series
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
9 Care and maintenance
Regular care and observation of some basic points
will ensure trouble-free operation and a long
service life of the unit.
The device should be checked and thoroughly
cleaned after each prolonged use, but in any case
at least once per year
.
The entire plant may only be maintained or
repaired by specialist authorised firms.
DANGER!
Prior to performing any work, ensure the equip-
ment is disconnected from the voltage supply
and secured to prevent accidental switch-on!
1
Fig. 18: Remove filter
1 Filter
n Clean the equipment using a damp cloth. Do
not use a jet of water
.
n Do not use any caustic, abrasive or solvent-
based cleaning products.
n Only use suitable cleaning agents, even in the
event of severe soiling.
n Empty the condensate container and check if
the diameter of the condensate lines have
tapered as a result of soiling prior to and after
each operating season. If this is the case, they
must be cleaned.
NOTICE!
Check the level of dirt on the on the exchanger
fins.
n Clean the air filter on the indoor unit at regular
intervals, and more frequently if necessary
.
n It is recommended that you take out a mainte-
nance contract with an appropriate specialist
firm.
This enables you to ensure the operational reli-
ability of the plant at all times!
NOTICE!
Never operate the indoor unit without the orig-
inal filter
. The heat exchanger fins on the indoor
unit with soil up if operated without a filter and
the device will suffer performance loss.
Air filter for indoor unit
Clean the air filter at intervals of no more than 2
weeks. Reduce this interval if the air is especially
dirty
.
Cleaning the filter on the indoor unit
Please proceed as follows in order to clean the
unit:
1. Remove the mains plug.
2. Pull the filter out of the unit (Fig. 18).
3. Clean the filter of dust. Use a vacuum
cleaner in the event of slight soiling.
4. In the event of more severe soiling, carefully
clean in lukewarm water
.
5. Subsequently allow the filter to dry in the air
.
6. Insert the filter back into the device.
REMKO RKL DC series
20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the REMKO RKL DC Series and is the answer not in the manual?

REMKO RKL DC Series Specifications

General IconGeneral
BrandREMKO
ModelRKL DC Series
CategoryAir Conditioner
LanguageEnglish

Related product manuals