03
Before You Start
This quick start guide will take you through the few steps
required to connect and start using your station.
This guide is based on NAP-7.
NAP-3 / NAP-5 have different number of antennae.
Please refer to “Interface” in this guide.
This “Before you start” is a session for the physical installation of the
NAP device to the Ethernet and LTE environment.
Regarding the Wi-Fi configuration or the other connection process,
please refer to the session “Activation / Configuration”.
The locational information including GNSS coordinates
MUST be entered during the configuration.
For further details, please visit https://service.rs-aiot.com/
Prepare the following to Access Station Micro System
•Internet connection: either by Ethernet port or compatible LTE Cat-M1
•In case of using Ethernet network: Ethernet cable
CAT5e or above, shielded F/FTP, SF/UTP, SF/FTP
•In case of using LTE M1 : Micro SIM card registered with mobile operator
•Indoor 220 / 110 V AC power outlet
•Antennas come attached. *Sim cards are not provided
To Next Page
Loading...