WARNING!
Ensure input DC voltage ≤Max. DC voltage .Over voltage may cause
permanent damage to inverter or other losses, which will not be
included in warranty!
Authorized service personnel must disconnect both AC and DC power
from inverter before attempting any maintenance or cleaning or working
on any circuits connected to inverter.
Do not operate the inverter when the device is running.
Risk of electric shock!
Prior to the application, please read this section carefully to ensure correct and safe
application. Please keep the user manual properly.
Accesories only together with the inverter shipment are recommanded here. Otherwise may
result in a risk of fire, electric shock, or injury to person.
Make sure that existing wiring is in good condition and that wire is not undersized.
Do not disassemble any parts of inverter which are not mentioned in installation guide. It
contains no user-serviceable parts. See Warranty for instructions on obtaining service.
Attempting to service the inverter yourself may result in a risk of electric shock or fire and will
void your warranty.
Keep away from flammable, explosive materials to avoid fire disaster.
The installation place should be away from humid or corrosive substance.
Authorized service personnel must use insulated tools when installing or working with this
equipment.
PV modules shall have an IEC 61730 class A rating.
Never touch either the positive or negative pole of PV connecting device. Strictly prohibit
DANGER OF BURN INJURIES DUE TO HOT ENCLOSURE PARTS!
During operation, the upper lid of the enclosure and the enclosure body
may become hot.
Only touch the lower enclosure lid during operation.
POSSIBLE DAMAGE TO HEALTH AS A RESULT OF THE EFFECTS OF
RADIATION!
Do not stay closer than 20 cm to the inverter for any length of time.
NOTE!
Grounding the PV generator.
Comply with the local requirements for grounding the PV modules and
the PV generator. Renac Power recommends connecting the generator
frame and other electrically conductive surfaces in a manner which
ensures continuous conduction and ground these in order to have
optimal protection of the system and persons.
To Next Page
Loading...
