TYRE PRESSURE LOSS WARNING
3
the system must be reset with a tyre
inflation pressure (reference values)
🡺336.
Resetting should always be carried
out after checking the tyre pressure
of all four tyres when cold.
In the following situations, the sys-
tem risk coming into action late or
not functioning correctly:
– system not reset after reinflation
or any operation on the wheels;
– incorrectly reset system: tyre pres-
sures different from the recom-
mended pressures;
– significant change in load or distri-
bution of load on one side of the ve-
hicle;
– sporty driving with strong acceler-
ation;
– driving on snowy or slippery sur-
face;
– driving with snow chains;
– fitting a single new tyre;
– use of tyres not approved by the
network.
The tyre pressure must be
checked before starting
the resetting procedure.
The system will not issue a
warning if the pressure does not
correspond to the recommend-
ed pressure.
A sudden loss of pressure
in a tyre (burst tyre, etc.)
may not be immediately
detected by the system.
Procedure for resetting the
tyre pressure reference value
This should be performed:
– after each re-inflation or resetting
of tyre pressure;
– after changing a wheel;
– after changing wheels around.
Tyre pressures must correspond to
the current usage of the vehicle
(empty, carrying a load, motorway
driving, etc.). Respect the tyre pres-
sures (including the emergency
spare wheel). Check them at least
once a month and before a long jour-
ney (refer to the label on the edge of
the driver’s door 🡺336).
Resetting procedure
Vehicles not fitted with a multime-
dia screen
Ignition on, vehicle stopped:
– on vehicles equipped with a type
A
or
B
🡺112 instrument panel, press
switch
3
as many times as neces-
sary to reach the "Vehicle" world;
– briefly press switch
4
or
5
to reach
the "Tyre pressure init. long press"
page
7
;
200 - Driving
To Next Page
Loading...
