SEAT BELTS
2
|
42 - Getting to know your vehicle
– a beep is emitted for 35 seconds;
and
– the
8
symbol is displayed for at least
65 seconds and the symbol for the
seat concerned changes to red.
Always make sure that the rear pas-
sengers are properly fastened in and
that the number of seat belts indicated
corresponds to the number of rear
seats occupied.
– No modification may
be made to the compo-
nent parts of the original-
ly fitted restraint
system:seat belts,seats and their
mountings. For special operations
(e.g. fitting child seats), contact
an authorised dealer.
– Do not use devices which allow
any slack in the belts (e.g. clothes
pegs, clips, etc.): a seat belt
which is worn too loosely may
cause injury in the event of an ac-
cident.
– Never wear the shoulder strap
under your arm or behind your
back.
– Never use the same belt for
more than one person and never
hold a baby or child on your lap
with your seat belt around them.
Adjusting the rear seat belts
Adjusting the second row side seat
belts
Slowly unwind belt
9
and click latch
10
into red buckle
11
. In all cases,
check that the seat belts are operating
correctly.
To Next Page
Loading...
