HEADLIGHT BEAM ADJUSTMENT
2
Knob
A
is used to adjust height of
the headlight beam according to
load. Turn knob
A
anticlockwise to
lower the beams and clockwise to
raise them.
Examples of
positions for
adjusting the
knob
A
ac-
cording to the
load
Only Driver Zero
Driver + front pas-
senger
Zero
Driver + Trunk o
Driver + All pas-
sengers
oo
Driver + All
passengers+Trunk
ooo
Temporary adjustment
Open the bonnet and identify the
marking
B
next to one of the front
headlight projectors.
For each headlight, use a screwdriv-
er to turn the screw
1
a quarter of a
turn towards the "-" symbol to lower
the beams.
Return to the original position once
your trip is over: turn the screw
1
a
quarter of a turn towards the "+"
symbol to raise the beams.
Getting to know your vehicle - 51
|
To Next Page
Loading...
