Renault KWID 2025 - Page 71

TYRE PRESSURE MONITIORING SYSTEM
3
– after switching the wheels of the
same axle (you must not switch be-
tween the front and rear wheels).
It should always be done after
checking the tyre pressure of all four
tyres when cold.
Tyre pressures must correspond to
the current usage of the vehicle
(empty, carrying a load, motorway
driving, etc.).
Resetting procedure
Ignition on, vehicle stationary:
– press button B. briefly several
times to select the function “SET
TYRE PRESSURE” is displayed on the
Instrument panel.
– press and hold (around 3 seconds)
button B to start initialization. If the
“SET ” warning light flashes or
text message in Instrument
panel“TPMS ONGOING” for approxi-
mately 5 seconds accompanied by a
constant illumination of the “SET
” warning light, this indicates
that the request for reinitialization of
the tyre pressure reference value
has been correctly registered.
Reinitialization is carried out after a
few minutes’ driving.
Readjustment of tyre pressures
The tyre pressure must be adjusted
when the tyres are cold.
If the tyre pressures cannot be
checked when the tyres are cold, the
recommended pressures must be in-
creased by 0.2 to 0.3 bar (3 PSI).
Never deflate a hot tyre.
After each reinflation or readjust-
ment of the tyre pressure, launch the
reinitialisation of the tyre pressure
reference value.
Inflate tyres and reset
The 1 warning light comes on
along with . 2 is displayed in
red
This indicates that at least one tyre
is flat or punctured.
In the event of a flat tyre, inflate the
relevant tyre.
In the event of a puncture, change
the tyre or consult an authorised
dealer.
It is not recommended to drive the
vehicle if a tyre is punctured. This
may cause tyre to damage. Refer
chapter 🡺121.
|
70 - Driving