Renault TWINGO - Trip Computer and Warning System

ordinateur de bord .................................... (jusqu’à la fin de l’UD)
tableau de bord ........................................ (jusqu’à la fin de l’UD)
afficheur ....................................................
(jusqu’à la fin de l’UD)
1.51
ENG_UD1340_1
Ordinateur de bord (X44 - Renault)ENG_NU_773-1_X44_Renault_1
Ordinateur de bord
TRIP COMPUTER AND WARNING SYSTEM
Display 1
General reset and trip
mileage recorder reset key 2
Press and hold button 2 to reset the trip
mileage recorder. The display must be
set to “Trip mileage recorder”.
Display selection key 1
Press button 2 repeatedly to scroll
through the following information:
– total mileage;
– trip mileage recorder;
– programmed speed (speed limiter/
cruise control);
– time (depending on vehicle);
– temperature (depending on vehicle);
– mileage before service.
Refer to the tables on the following
pages for display examples.
Note: resetting is automatic when
the maximum capacity of any of the
memories is exceeded.
1
2
Instrument panel in miles
It is possible to switch to km/h.
Press button
2 and switch on the igni-
tion.
The speed measurement unit indica-
tor flashes for approximately three sec-
onds, then the new unit flashes on the
display and is then lit up continuously:
release button 2.
To return to miles, proceed in the same
manner.
Note: once the battery is disconnected,
the trip computer and warning system
automatically returns to the original unit
of measurement.