Renault TWINGO - RUNNING IN; IGNITION SWITCH

antivol (contacteur) ................................... (jusqu’à la fin de l’UD)
contacteur de démarrage ......................... (jusqu’à la fin de l’UD)
démarrage moteur .................................... (jusqu’à la fin de l’UD)
rodage ...................................................... (jusqu’à la fin de l’UD)
conduite .................................................... (jusqu’à la fin de l’UD)
2.2
ENG_UD1352_1
Rodage (X44 - Renault)ENG_NU_773-1_X44_Renault_2
Rodage - Contacteur de démarrage
Petrol version
For the first 600 miles (1, 000 km), do
not exceed 78 mph (130 km/h) in the
highest gear or 3,000 to 3,500 rpm.
After 600 miles (1,000 km), you may
use your vehicle normally, although you
may only expect top performance after
approximately 1,800 miles (3,000 km).
Service intervals: refer to the
Maintenance Service Booklet for the
vehicle.
Diesel version
For the first 900 miles (1,500 km), do
not exceed 2,500 rpm. After complet-
ing this mileage you may drive faster,
although you may only expect top
performance after approximately
3,600 miles (6,000 km).
During the running in period, do not ac-
celerate hard while the engine is still
cold and do not let the engine over-rev.
Service intervals: Refer to your
Maintenance Service Booklet for de-
tails of subsequent service intervals.
RUNNING IN
“Stop and steering lock” position:
first position
To lock: remove the key and turn the
steering wheel until the steering column
locks.
To unlock: turn the key and the steering
wheel slightly.
“Accessories” position: second
position
When the ignition is switched off, any
accessories (radio, etc.) will continue to
function.
IGNITION SWITCH
“On” position: third position
The ignition is switched on:
– petrol version: you can start the
vehicle;
– diesel version: the engine is pre-
heating.
“Start” position: fourth position
If the engine fails to start at the first
attempt, the key must be turned back
before the starter can be activated
again. Release the key as soon as the
engine starts.
Note: on diesel versions, several sec-
onds may pass between turning the
key and the engine starting to allow for
engine preheating.
Special note on vehicles with a
Quickshift gearbox
Depress the brake pedal with the lever
in the N position.
Note: If a gear other than neutral is dis-
played, it flashes; starting is not possi-
ble unless you depress the brake pedal,
while holding the key in the starting po-
sition.