EasyManuals Logo

Renesas e1 User Manual

Renesas e1
45 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
E1/E20/E2/E2 Lite Additional Document Terminology
R20UT2937EJ0301 Rev.3.01 Page 6 of 45
Jul 1, 2020
Terminology
Some specific words used in this user's manual are defined below.
Host machine
This means a personal computer used to control the emulator.
User system
This means a user's application system in which the MCU to be debugged is used.
User program
This means the program to be debugged.
Programming Software
In this document, this indicates Renesas Flash Programmer that can be used with the E1, E20, E2, or
E2 Lite.
"#" at the end of a pin name (signal name)
"#" at the end of a pin name (signal name) indicates that the pin (signal) is active low (e.g., RESET#).
Extended function of the E2
This means an extended function which is available with the E2 emulator.
E2 expansion interface
This means the interface required for extended functions of the E2 emulator.

Table of Contents

Other manuals for Renesas e1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Renesas e1 and is the answer not in the manual?

Renesas e1 Specifications

General IconGeneral
Host InterfaceUSB
On-Chip DebuggingYes
ManufacturerRenesas Electronics
Product CategoryDebug Emulators
Target MCU FamilyRenesas MCUs
ProgrammingSupported
Power SupplyUSB
CategoryEmulators
Supported DevicesRenesas MCUs

Related product manuals